Universal Electronics Millenium 4 Guía de usuario descargar pdf (Pagina 25)

CHECKING THE CODES

If you have set up the Millennium 4 using the Searching

For Your Code procedure, you may need to find out which

four-digit code is operating your equipment:

For example, to find out which code is operating your TV:

1. Turn on your TV.

2. On the Millennium 4, press and hold SETUP

until the LED blinks twice, then release SETUP.

3. Enter 9 - 9 - 0. The LED will blink twice.

4. To view the code for the first digit,press 1 once.

Wait 3 seconds and count the number of LED

blinks (e.g., 3 blinks = 3) and write down the

number in the leftmost TV Code box below.

NOTE: If a code digit is “0”, the LED will not blink.

5. Repeat step 4 three more times for remaining

digits. Use 2 for the second digit, 3 for the third

digit, and 4 for the fourth digit. Finish writing

down the code in the TV Code boxes below.

6. To check for the codes of your other

components,repeat steps 1 through 5, but

substitute the appropriate key (i.e., VCR, CBL,

or AUDIO) for the (VCR or DVD, Cable, or

Audio) component you are checking.Write

down the codes in the appropriate boxes below.

TV Code

VCR (or DVD Player) Code

CBL Code

AUDIO ___________________ Code

Millennium 4 Mnl M4094 rev 12/27/02 11:00 AM Page 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Sin comentarios

Universal Electronics Millenium 4 Guía de usuario Pagina 25